Search results for "digital Incubator Thermostat":

The Plug ‘n Play is a digital electronic thermostat with remote sensor designed specifically for incubators. It's great for both tabletop and cabinet incubators. It comes pre-wired and ready to use. You can use any heating element up to 225 Watts. Simply plug in your heater, heat mat, or light bulb to the 3 outlet plug outlet and you’re ready to go. The temperature can be adjusted in 0.1 degree increments. Just press the up or down arrow to set it. The screen has a flame icon that turns on when the heater is operating. This unit comes with a 24 inch remote sensor that can be placed inside your incubator. The white thermostat may be mounted on the outside of the incubator. Comes preset to 99.5 degrees F (37.5 in Celsius mode). Set point can be adjusted to any temperature between 41-113 degrees F If the temperature goes over 99.9, it reads: 00.1, 00.2, 00.3, etc. The digital readout displays temperature to the tenth of a degree (98.7, 99.4) The temperature switching differential is 0.2 degrees F. This means that if the temperature is set to 99.5 then the thermostat will turn the heat on when the thermostat sensor reads below 99.3 and turn off when the sensor reads above 99.7 110V AC Calibration enabled. This means that you can calibrate the thermostat if required. For example, if you have a thermometer that you trust and the digital thermostat reads a little different, you can calibrate the thermostat to match the trusted thermometer (calibrate in 0.1 degree increments up to +/- 5 degrees) Key lock feature allows you to set the temperature and lock the keys so it cannot be changed without unlocking the keys (keys are locked by pressing both up and down buttons for 5 seconds) Note: It is normal for the thermostat to turn the heater off and still have the air temperature increase a little bit. This happens because as the power to the heater turns off, the heater is still hot and will heat the air around it. The same is true when the heater turns back on: the temperature may decrease a little more as the heater gets back up to temperature. The amount this happens will depend on the amount of heat your heating element holds and the amount of circulation in your incubator. Keep in mind that the air temperature may vary without a negative impact to the eggs if the variation is rapid enough to not allow the eggs to heat or cool more than it should. As long as the up and down cycle is relatively small, less than a few minutes, and the average air temperature is at your target temperature, the temperature inside your egg (which is what really matters) will be just fine! This is true with any incubator and egg configuration. As always, all of our products are covered by our 2 Year IncuCare Warranty. Purchase today with no worries and experience the Plug ‘n Play Digital Electronic Thermostat for yourself.

HovaBator 1602N Egg Incubator with Fan (Model 1091) If you’re looking for a reliable yet affordable incubator, look no further. The HovaBator 1602N is a simple, easy-to-use incubator that is relatively low-cost. All these things combined have made this incubator a bestseller. The HovaBator 1602N is the perfect incubator for anyone new to hatching eggs or who wants to save money while still getting the maximum performance out of their incubator. Features: Incubator Warehouse Gentle Flow Fan kit Reliable wafer snap thermostat for accurate temperature control Washable plastic sanitary liner for easy cleaning Styrofoam construction provides excellent insulation Removable water trough for humidity control Two viewing windows to watch eggs as they hatch IncuTurn™ Automatic Egg Turner for HovaBator Egg Incubators Carefully engineered and tested the universal egg tray holds any size egg, saving you from purchasing expensive egg racks for different egg sizes. Eggs are gently rolled six times per day, similar to how they are turned in nature, preventing the yolk from settling and exercising the embryo. The universal egg tray can hold 42 Chicken, 70 Quail, or 28 Goose eggs. Installation is a breeze, simply slide the motor clip over the edge of the incubator and attach the turning tray and you’re ready to start incubating. This product is a direct replacement for all HovaBator Egg Turners. Guaranteed to outperform the HovaBator Egg Turners*. This is a 110V version, purchase the voltage converter for 220/240V use.   Quail Tray for IncuTurn™ (Optional Selection) The Quail egg tray holds quail and small bird eggs and increases egg capacity to 116 quail eggs versus the 70 quail eggs that the universal tray can hold.   Incubator Warehouse Hatch Guidebook This illustrated 28-page book is the printed version of our 4-Part Intro to Hatching YouTube Series (see video links below). It gives a basic introduction to incubating eggs and brooding chicks.   YouTube Video Series Intro to Hatching Part 1/4: Setup https://www.youtube.com/watch?v=MqnbL8qTvaI&t Intro to Hatching Part 2/4: Incubation Period https://www.youtube.com/watch?v=vq8NvC2mH0U&t Intro to Hatching Part 3/4: Hatching Period https://www.youtube.com/watch?v=e3JzvNvvRpU&t Intro to Hatching Part 4/4: After Hatch https://www.youtube.com/watch?v=L7gtp3QQWgY&t   HumidiKit™-Auto Humidity System (Optional Selection) The answer to one of the common hassles with incubation is maintaining the humidity inside the incubator. No need to frequently fill the water reservoirs or struggle to maintain the desired humidity. This system is designed to instantly deliver accurate humidity to most incubators. The integrated digital hygrostat that measures and controls the humidity is fully adjustable so you can achieve the right humidity range for your eggs. The humidifier is designed to gently provide instant humidity and fresh air directly inside the incubator for an accurate humidity range. The humidifier also comes with a one-liter bottle which typically needs to be filled once a week for most desktop incubators. To extend the life of your HumidiKit we recommend using distilled water. This unit comes ready to install into your incubator; simply place the probes from the HumidiKit inside the incubator, insert the hose into a vent hole, fill the water bottle, and connect to power.   Includes 2-Year IncuCare Warranty!

HovaBator 1602N Egg Incubator with Fan (Model 1091) If you’re looking for a reliable yet affordable incubator, look no further. The HovaBator 1602N is a simple, easy-to-use incubator that is relatively low-cost. All these things combined have made this incubator a bestseller. The HovaBator 1602N is the perfect incubator for anyone new to hatching eggs or who wants to save money while still getting the maximum performance out of their incubator. Features: Incubator Warehouse Gentle Flow Fan kit Reliable wafer snap thermostat for accurate temperature control Washable plastic sanitary liner for easy cleaning Styrofoam construction provides excellent insulation Removable water trough for humidity control Two viewing windows to watch eggs as they hatch   IncuTurn™ Automatic Egg Turner for HovaBator Egg Incubators Carefully engineered and tested the universal egg tray holds any size egg, saving you from purchasing expensive egg racks for different egg sizes. Eggs are gently rolled six times per day, similar to how they are turned in nature, preventing the yolk from settling and exercising the embryo. The universal egg tray can hold 42 Chicken, 70 Quail, or 28 Goose eggs. Installation is a breeze, simply slide the motor clip over the edge of the incubator and attach the turning tray and you’re ready to start incubating. This product is a direct replacement for all HovaBator Egg Turners. Guaranteed to outperform the HovaBator Egg Turners*. This is a 110V version, purchase the voltage converter for 220/240V use.   Quail Tray for IncuTurn™ (Optional Selection) The Quail egg tray holds quail and small bird eggs and increases egg capacity to 116 quail eggs versus the 70 quail eggs that the universal tray can hold.   Incubator Warehouse Hatch Guidebook This illustrated 28-page book is the printed version of our 4-Part Intro to Hatching YouTube Series (see video links below). It gives a basic introduction to incubating eggs and brooding chicks.   YouTube Video Series Intro to Hatching Part 1/4: Setup https://www.youtube.com/watch?v=MqnbL8qTvaI&t Intro to Hatching Part 2/4: Incubation Period https://www.youtube.com/watch?v=vq8NvC2mH0U&t Intro to Hatching Part 3/4: Hatching Period https://www.youtube.com/watch?v=e3JzvNvvRpU&t Intro to Hatching Part 4/4: After Hatch https://www.youtube.com/watch?v=L7gtp3QQWgY&t   Incubator Warehouse EZ-Clean Chick Brush for Cleaning Incubators & Eggs Cute Chick Brush for cleaning incubator or Eggs. 3 in x 4 in   IncuBright™ Egg Candler One of the most exciting parts of incubating eggs is being able to watch the embryo progress during the various development stages. The IncuBright™ egg candler makes this joy possible by providing an easy and effective way to candle your eggs. It uses the latest in LED light technology, having one super bright CREE bulb the IncuBright™ illuminates your eggs for easy viewing, even with dark or large eggs. It has the only universal silicone rubber egg protector ring that lets you candle any size egg and is cordless making it easy to use (batteries included).   E-Z Water Filler 12 oz The EZ Incubator Water Trough Filler makes the task of adding water accurately to any incubator a breeze. No more spilling water, overfilling, or guessing where your water will go.   HumidiKit™-Auto Humidity System (Optional Selection) The answer to one of the common hassles with incubation is maintaining the humidity inside the incubator. No need to frequently fill the water reservoirs or struggle to maintain the desired humidity. This system is designed to instantly deliver accurate humidity to most incubators. The integrated digital hygrostat that measures and controls the humidity is fully adjustable so you can achieve the right humidity range for your eggs. The humidifier is designed to gently provide instant humidity and fresh air directly inside the incubator for an accurate humidity range. The humidifier also comes with a one-liter bottle which typically needs to be filled once a week for most desktop incubators. To extend the life of your HumidiKit we recommend using distilled water. This unit comes ready to install into your incubator; simply place the probes from the HumidiKit inside the incubator, insert the hose into a vent hole, fill the water bottle, and connect to power.   Includes 2-Year IncuCare Warranty!