Search results for "egg incubator":

  Incubator Warehouse's Digital Electronic Egg Incubator Thermostat for IncuKit XL Description: This thermostat is very simple to use. Just press the up arrow to set the temperature (in 0.1 degree increments). There is a flame indicator on the screen that shows when the heater is operating. The unit has an 18 inch remote sensor that is placed inside the incubator. The white thermostat case is then mounted on the outside of the incubator. Finally you can measure the temperature right next to your eggs, not the air at the top of the incubator. This can be set to read in Celsius or Fahrenheit Comes preset to 99.5 (this means that if you lose power the thermostat will come back on set to 99.5) - Preset to 37.5 in Celsius mode Digital readout displays temperature to the tenth of a degree (examples: 98.0, 99.5) If the temperature goes over 99.9, it reads: 00.1, 00.2, 00.3, etc Designed specifically for incubators, great for small incubators AND cabinet incubators (can switch heating elements up to 225 Watts) Remote Temperature Sensor (18 inches long) 110V AC Power Temperature Switching Differential = 0.2 degrees Fahrenheit. This means if the thermostat is set to 99.5 the thermostat will turn the heat on when the thermostat sensor reads below 99.3 and turn off when the sensor reads above 99.7. NOTE: It is normal for the thermostat to turn the heater off and still have the air temperature increase a little bit. This happens because as the power to the heater turns off, the heater is still hot and will heat the air around it. The same is true when the heater turns back on: the temperature may decrease a little more as the heater gets back up to temperature. The amount this happens will depend on the thermal mass of your heating element and the amount of circulation in your incubator. Keep in mind that the air temperature may vary without a negative impact to the eggs if the variation is rapid enough to not allow the egg to heat or cool more than it should. As long as the up and down cycle is relatively small, is less than a few minutes, and the average air temperature is at your target temperature, the temperature inside your egg (which is what really matters) will be just fine! This is true with any incubator and egg configuration. Calibration Enabled. This means that you can calibrate the thermostat to a specific temperature. For example: If you have a thermometer that you trust and the digital thermostat reads a little different, you can calibrate the thermostat to match the trusted thermometer (calibrate in 0.1 degree increments up to +/- 5 degrees) Wiring and operation instructions included. It also includes instructions for installing an incubator fan, if desired. Key lock feature allows you to set the temperature and lock the keys so it cannot be changed without unlocking the keys (keys are locked by pressing both up and down buttons for 5 seconds).  

This is an OEM replacement thermostat for the HovaBator Genesis 1588 egg incubator. This purchase comes with the Incubator Warehouse 2 year IncuCare Warranty. 

Putting a fan inside your incubator is a great way to increase hatch rates, but it is not just as simple as buying a PC fan or a cheap fan kit. There are a few things that you need to keep in mind: Too much air circulation is BAD for eggs (it will dry them out). Think about it, in nature there isn't a fan blowing on eggs. The only reason that an incubator needs the fan is to keep the temperature more consistent (like in nature). BEWARE of CHEAP kits. They often use regular HIGH speed fans. Almost all the fans on the market are designed to move as much air as possible. This is not what you want. If you get too powerful of a fan it can OVERHEAT your incubator. Fans generate heat. Many people have come to check on their eggs only to find them cooked because the fan caused the incubator to overheat. The direction the air flows and the positioning of the fan inside your incubator is critical to maintaining a consistent temperature throughout the incubator. Highlights of the Incubator Warehouse Circulated Air Fan Kit for the Little Giant 9300 Tested & proven for the Little Giant Incubator to increase hatch rates Specially designed to move only as much air as necessary to keep the incubator temperature consistent Will not overheat your incubator!!! Full color installation instructions for an easy installation Backed by the Incubator Warehouse TWO YEAR HASSLE FREE GUARANTEE Did you know that at any given time the temperature in your Little Giant still air incubator can vary by up to 5 degrees from the top and bottom and from the center to the corners? In addition, you get variation from the thermostat cycling the heating unit on and off. This temperature variation has a significant impact on your hatch rates. This problem can be significantly reduced by installing a circulated air fan kit into you incubator. Heat naturally rises, so you need to circulate the hot air from the hot spots to the cool spots for a much more uniform and consistent temperature and better hatch results. The more consistent air temperature also ensures that your thermostat is cycling on and off at the appropriate times, not just when the air around the thermostat heats or cools. Installation Video: 9300 Fan Installation Guide

This set of six quail rails will adapt your Little Giant Automatic Egg Turner to work for quail. Each of the six rails hold 20 eggs, for a total capacity of 120 eggs. Each rail is made of durable dishwasher safe plastic for easy cleaning. Additional accessories can be purchased for your incubator to improve your hatch rate and your overall experience, including an Egg-O-Meter, an IncuTherm Plus hygrometer/thermometer, and an Incu-Bright egg candler. This item, along with the majority of our products, is covered by our Two Year IncuCare Warranty. Purchase today with no worries and experience the Little Giant Quail Rails yourself. User Guide [PDF] PLEASE NOTE: This purchase ONLY includes small egg racks (turner is NOT included). These rails DO NOT work in any Hova-Bator Egg Turner.

Most of our products use 110V AC power, but we sell of lots of incubators internationally, and other countries use 220/240V AC power, so we've created a converter kit. It provides everything you need to power ONE Little Giant OR HovaBator Egg Incubator Combo Kit (Incubator, Fan Kit, and Egg Turner) internationally. This power converter kit is specially designed for continuous use (most power converters will wear out under constant use). Converts 220/240V AC power to 110V AC power, UP TO 100 Watts. This item, along with the majority of our products, is covered by our Two Year IncuCare Warranty. Purchase today with no worries and experience the 220/240V Voltage Converter Kit for yourself.

This thermometer is included with all wafer thermostat Hova-Bator incubators produced after 2001 but may be used with any incubator. This lightweight thermometer is intended to be placed directly on top of the eggs so that it reads the temperature at egg level. Dimensions: 6.5'' X 3.5''

This extension adapts the IncuKit XL to work for larger reptile incubators. Without this adapter, the fan stays on constantly. This adapts the wiring so that the fan and heater turn off once the set temperature is reached. This helps to keep the incubator from overheating when the set temperature is close to the room temperature. And it keeps the air from circulating too much, which would tend to dry the eggs out.

This circulated air fan kit comes ready for instalation in your GQF 9300 egg incubator. Did you know that at any given time the temperature in your Little Giant Still Air incubator (9300) can vary by up to 5 degrees from the top and bottom and from the center to the corners? In addition, you get variation from the thermostat cycling the heating unit on and off. This temperature variation has a significant impact on your hatch rates. Heat naturally rises, so you need to circulate the hot air from the hot spots to the cool spots for a much more uniform and consistent temperature and better hatch results. The more consistent air temperature also ensures that your thermostat is cycling on and off at the appropriate times, not just when the air around the thermostat heats or cools.Includes step by step installation instructions. (Miller Item Number 7300)

INCUBATORWAREHOUSE.COM's FLEW WATT heat tape clips and insulators These are especially designed for use with Flex Watt heat tape. Flex Watt is dependable, cost effectiveness and easy to use! Each set comes with everything you need to make the electrical connections between a power cord or dimmer and your flex watt heat tape. The tape is a special ultra thick self-fusing tape that creates an almost permanent bond. Please note the price is PER SET of two clips and insulators for each (everything you see in the picture). Feel free to take a moment or two to review our feedback so you can buy with complete confidence. Check out our ebay store for additional items for your animal heating and egg-hatching needs. Simply click here: https://stores.ebay.com/Incubator-Warehouse Please feel free to email us with any questions.