The two biggest factors in achieving a successful hatch are correct temperature and humidity. With these factors in mind, we created the IncuTherm™ series digital thermometer/hygrometers.
The IncuTherm Plus™ is able to accurately measure and display the temperature and relative humidity at the same time which can be displayed in both Fahrenheit or Celsius . The probe is placed inside the incubator. This allows the IncuTherm Plus™ to measure temperature and humidity on the inside of your incubator and display it on the outside. The built-in high and low memory stores the highest and lowest temperature and humidity readings since the last memory reset. This helps you ensure ideal conditions for a successful hatch.
The IncuTherm Series has been factory calibrated to be accurate to within +/- 1°F (0.5°C) in the incubation temperature ranges. This is twice as accurate as most standard digital thermometers available on the market. This accuracy level makes the IncuTherm Series the easy choice when selecting a digital thermometer for your next hatch.
As always, all of our products are covered by our One-year Hassle-free Guarantee. Purchase today with no worries and experience the IncuTherm Plus™ Hatch Monitor for yourself.
QUESTIONS & ANSWERS
Ask a Question-
What is the accuracy of this thermometer?
We recognize it is incredibly difficult to find thermometers that are accurate and match other thermometers. The IncuTherm™ Series has an range of + or - one degree for accuracy. This means if your Incutherm™ reads 99.5 degrees Fahrenheit the actual temperature can be between 98.5 and 100.5 degrees Fahrenheit. Our Incutherm™ series is specifically designed to give accurate readings to improve your hatching experience. If you have any issues please contact our friendly customer service agents.
-
Will this probe of the IncuTherm Plus™ Hatch Monitor fit into the vent hole of the Janoel 12 incubator?
Sadly the IncuTherm Plus™ Hatch Monitor probe will not fit through the vent hole of the Janoel 12 incubator. However, you can place the whole unit on the inside between the side of the turner tray and the clear exterior wall. The IncuTherm™ Temp/Humidity Gauge also fits very well in the small area between the turner tray and clear wall allowing you to easily read the humidity levels and temperature.
-
Is the probe designed so that the actual sensor is safe from mist or a quick spray, as might be encountered in a vivarium used for dart frogs and the like?
The probe is meant to withstand incubation temps and humidity levels, it should do just fine in a dart frog enclosure as well.
-
Will the probe unplug from the unit so that you could back feed the probe through the vent hole of a genesis 1588?
It will not unless the probe cover is removed, then you can carefully place the probe through the vent hole and the put the probe cover back on.
-
What is the probe dimensions?
The probe is about 2 inches long and .5 inches wide.
-
Will this probe fit through the hole in the top of the IncuView?
No, the probe on the IncuTherm Plus will not fit through the vent hole on an IncuView.
Product Instructions & Documents