Plug 'n Play Digital Electronic Thermostat with Remote Sensor
$66.99
The Plug ‘n Play is a digital electronic thermostat with remote sensor designed specifically for incubators. It's great for both tabletop and cabinet incubators. It comes pre-wired and ready to use. You can use any heating element up to 225 Watts. Simply plug in your heater, heat mat, or light bulb to the 3 outlet plug outlet and you’re ready to go. The temperature can be adjusted in 0.1 degree increments. Just press the up or down arrow to set it. The screen has a flame icon that turns on when the heater is operating. This unit comes with a 24 inch remote sensor that can be placed inside your incubator. The white thermostat may be mounted on the outside of the incubator. Comes preset to 99.5 degrees F (37.5 in Celsius mode).
Set point can be adjusted to any temperature between 41-113 degrees F
If the temperature goes over 99.9, it reads: 00.1, 00.2, 00.3, etc.
The digital readout displays temperature to the tenth of a degree (98.7, 99.4)
The temperature switching differential is 0.2 degrees F. This means that if the temperature is set to 99.5 then the thermostat will turn the heat on when the thermostat sensor reads below 99.3 and turn off when the sensor reads above 99.7
110V AC
Calibration enabled. This means that you can calibrate the thermostat if required. For example, if you have a thermometer that you trust and the digital thermostat reads a little different, you can calibrate the thermostat to match the trusted thermometer (calibrate in 0.1 degree increments up to +/- 5 degrees)
Key lock feature allows you to set the temperature and lock the keys so it cannot be changed without unlocking the keys (keys are locked by pressing both up and down buttons for 5 seconds)
Note: It is normal for the thermostat to turn the heater off and still have the air temperature increase a little bit. This happens because as the power to the heater turns off, the heater is still hot and will heat the air around it. The same is true when the heater turns back on: the temperature may decrease a little more as the heater gets back up to temperature. The amount this happens will depend on the amount of heat your heating element holds and the amount of circulation in your incubator. Keep in mind that the air temperature may vary without a negative impact to the eggs if the variation is rapid enough to not allow the eggs to heat or cool more than it should. As long as the up and down cycle is relatively small, less than a few minutes, and the average air temperature is at your target temperature, the temperature inside your egg (which is what really matters) will be just fine! This is true with any incubator and egg configuration.
As always, all of our products are covered by our 2 Year IncuCare Warranty. Purchase today with no worries and experience the Plug ‘n Play Digital Electronic Thermostat for yourself.
Durable Seed Starter Kit with Heat Mat and Humidity Vents | 2 Sizes
$38.99
Start seeds faster with this amazing seed starting kit!
Fast Sprout Indoor Mini GreenhouseThe Fast Sprout Mini Greenhouse is unlike most of the humidity domes, mini greenhouses, & propagation domes on the market in the USA. This unit is made out of durable hard plastic (Most of them are made out of the same material as thin flimsy packaging). This unit is injection molded with crystal clear plastic and has 2 adjustable humidity vents on top. Stands 7.5" tall. Will last for years!!!!
8" x 12" x 7.5" Tall OR 22" x 11" x 7.5" Tall
Extra Thick Plastic, More Durable - Will Last for Years!!!
Great Light transmission
Faster sprout times
Inside dome lips keep humidity and condensation inside the dome (most units in USA allow water to flow out of dome)
2 Year IncuCare Warranty
Heat Sprout Germination MatThe Heat-Sprout Heat Mat was created with ease of use in mind. No more need to run multiple mats, just get the length you need. Ultra-thin construction & patented heating technology makes for a more uniform heat distribution and the durability to withstand rugged greenhouse environments. The Heat-Sprout is brand new on the market as of July 2010 and was designed with price, durability, & usability in mind.
Terminals & electrical connections are sealed using a high performance self fusing sealant
8" x 11" (Regular) OR 11" x 22" (Large) size is the exact fit for the tray and dome
Increases success of seedlings and cuttings
Warms root area 10-20˚F over ambient temperature to improve germination
No heat wires or thick pad, so heat is always dissipated evenly over the whole mat
Almost the entire surface of the mat is covered by the heat strips creating a very even
Moisture sealed electrical connections (Do not submerse in water)
6 foot power cord (Optional Rheostat/Dimmer with OFF and fully variable power)
Ultra-thin Super durable construction (No Multiple Plys, just one solid extra tough mat)
110-120V AC Power
2 Year IncuCare Warranty
Jiffy Brand Professional Peat Pellets (Seed Plugs)
Regular dome includes 1 set of 24 plugs (including the plastic insert tray)
Large dome includes 72 plugs (including plastic insert trays)
Fit perfectly in trays.
Great for seed starting
Just add water
Germination Mat Assembled in USA and all components made in the USA except the power cord!!
Heat-Sprout Seedling Heat Mat Germination | 4 Sizes
$0.00
The Heat-Sprout Heat Mat was created with ease of use in mind. No more need to run multiple mats, just get the length you need. Ultra-thin construction & patented heating technology provides a more uniform heat distribution and the durability to withstand rugged greenhouse environments. The Heat-Sprout was designed with price, durability, & usability in mind.
-Terminals & electrical connections are sealed using a high performance self fusing sealant-4 inch size is perfect for window sills and smaller trays and containers -Choose your custom size (For custom length orders, contact us) -Increases success of seedlings and cuttings -Warms root area 10-20˚F over ambient temperature to improve germination -No heat wires or thick pad, so heat is always dissipated evenly over the whole mat -Almost the entire surface of the mat is covered by the heat strips creating an even heat distribution -Moisture sealed electrical connections (Do not submerse in water) -Power cord (Optional Rheostat/Dimmer with OFF and fully variable power) -Ultra-thin Super durable construction (No Multiple Plys, just one solid extra tough mat) -Heat Strip, power cord, & dimmer are all UL Listed Components -110-120V AC Power
Assembled in USA!!